Surfacing ShopSabre CNC Router Spoil-board Guide

Spoilboard Surfacing Preflight

No ATC for Flycutter

T1: CMT 2.375"ø 3-wing Surfacer
  1. Manual Tool Insertion T1 (use L110 T1 to correct current WinCNC tool if needed)
  2. Set Tool Height (button on WinCNC)
  3. Set Z0 to top of spoilboard (vacuum on)
  4. X0Y0 is the standard corner of popup pins
  5. Run one of Files from /POSTS/2-375 BED SURFACE PROVEN/
  6. Flip sheet over and surface other side again to balance the spoilboard.

New spoilboard it is REQUIRED to remove 0.05" off each side for proper vacuum

Note: Suffix of File -03 = -.03" depth of cut from Z0


CMT 2.375"ø 3-Wing Cutter


Feeds and Speeds

  • 12,000 RPM
  • 400 IPM
  • 50% stepover
  • DOC: .03 to .05"
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us